INFICON PEG100 Medium to Ultra-High Vacuum Gauge - Manual (Page 13)

2.3 Start-up
Connect the PEG100 according to Section 2.1 and 2.2.
Warning A high tension which is dangerous when
touched is applied to the sensor in the
PEG100.
You must always switch off the supply
voltage for the PEG100 before starting
any work on the PEG100 (even when
removing the PEG100 from the connec-
tion flange) so as to avoid injury when
inadvertently coming in to contact with
the high tension.
2.3.1 Operation
Apply the 24 V supply voltage to the PEG100.
The orange „POWER“ LED (4/1) comes on.
Switch the high tension on via the high tension switching
input. See Section 2.2.2.
After successful ignition and at a pressure > 3·10 -9 mbar
the additional green or READY LED (4/2) will come on.
Now the PEG100 is ready to make measurements.
13
tina14e1 (0106) PEG100.ga
13
tina14e1 (0106) PEG100.ga
2.3 Start-up
Connect the PEG100 according to Section 2.1 and 2.2.
Warning A high tension which is dangerous when
touched is applied to the sensor in the
PEG100.
You must always switch off the supply
voltage for the PEG100 before starting
any work on the PEG100 (even when
removing the PEG100 from the connec-
tion flange) so as to avoid injury when
inadvertently coming in to contact with
the high tension.
2.3.1 Operation
Apply the 24 V supply voltage to the PEG100.
The orange „POWER“ LED (4/1) comes on.
Switch the high tension on via the high tension switching
input. See Section 2.2.2.
After successful ignition and at a pressure > 3·10 -9 mbar
the additional green or READY LED (4/2) will come on.
Now the PEG100 is ready to make measurements.
Fig. 4 PEG100 - front view
1
2
POWER READY
Key to Fig. 4
1 „POWER“ LED (orange)
2 „READY“ LED (green)
Fig. 4 PEG100 - front view
1
2
POWER READY
Key to Fig. 4
1 „POWER“ LED (orange)
2 „READY“ LED (green)