JUMO 705060 mTRON T - Multifunction Panel 840 Operating Manual - Manual (Page 49)

49
6 Multichannel controller module
This chapter describes the visualization and operation of the control channels and the program
generator.
Select the multichannel controller module or the program generator
The multichannel controller module or the program generator is selected via the button that is
highlighted.
Exit function
Touch the screen here to exit the function and return to the visualization from which it was
called up.
Prog. generator
After this function is called up, an overview of the nine program generators will be shown.
Touching an entry will open the corresponding generator screen.
 The operation of the program generators is described in operating manual B 705001.0
(central processing unit).
The program generators can also be controlled by a barcode scanner (select program number,
start and stop program).
 Chapter 16.2.3 "Program generator control", page 268
(1) (2)
(3)
(1) Exit function (2) Program generator
(3) Multichannel controller module (controller
screen)