JUMO 705060 mTRON T - Multifunction Panel 840 Operating Manual - Manual (Page 63)

63
7 Visualization
 Setup program:
HMI > C ONFIGURATION LEVEL > S CREEN > U SER OPERATING LEVEL
7.6 Digital
In this visualization, only the digital channels are displayed; the analog channels are not shown.
Sampling rate and operating mode
 Chapter 5.1.1 "Status line and Title line", page 42
Communication status
 Chapter 5.1.1 "Status line and Title line", page 42
Group selection
This function is used to directly select and display one of the active groups. Simply touch one
of the group designations displayed after calling up the function.
Memory display
This function is used to start the display of the data available in the history memory.
(1)
(3) (4) (5) (6) (7)
(2)
(1) Operating mode (2) Communication status
(3) Group selection (4) Memory display
(5) Numerical measured value display (6) Group rotation
(7) Home button
NOTE!
The function is only available if more than one group is active.