Leica Biosystems ST5010 Autostainer XL - Manual (Page 24)

Instructions for Use V 2.3 – 10/2012 24
5.4.2 Erasing steps
Information contained in a step may be erased leaving a blank step.
1. To select the program, see steps 1 to 3, page 22,
2. To select the step to be deleted, see step 4, page 22,
3. Press [F3] Erase.
The step will be left blank.
You may enter new step details, if desired.
4. To save the program, see page 24.
5.4.3 Inserting a blank step into a program
This function is used to insert an additional step into an existing program.
1. Select the program, see steps 1 and 2, page 22.
2. Press [F2] Edit .
3. Select the step number where the new (blank) step to be inserted.
4. Press [F1] More.
5. Press [F1] More.
6. Press [F1] Insert.
7. If you wish to proceed, press [F1] Yes.
A blank step will be inserted at the step selected in (3).
The steps following the blank step will be renumbered. Step
25 is lost when a blank step is inserted.
8. Continue to edit the program as required.
9. To save the program, see page 24.
5. Operation