Lenze PROFINET Controller-based Automation - Manual (Page 26)

6 Commissioning of the PROFINET
6.2 The commissioning steps in detail
26
Lenze · Controller-based Automation · PROFINET® Communication Manual · DMS 1.2 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.2.7 Configuring the communication parameters
Set the communication parameters to establish an online connection to the Lenze controller later
on.

How to configure the communication parameters:
1. Go to the Communication settings tab of the target system (device, Lenze Controller ...) and
click the Add gateway button.
Then go to the Gateway dialog box and enter the IP address of the controller. (By
double-clicking the predefined value it can be overwritten.)
2. Confirm the entry by clicking OK.