Commissioning – Lenze SMVector RS-485 LECOM User Manual
Page 27
25
CMVLC401A
Commissioning
9.3
Terminal and Protection Status (P530)
When a read command is issued over the LECOM network to Programming Parameter P530 (code number 1530), the
Terminal and Protection Status data returned can be interpreted as follows:
Data Low Byte
0 TB-13D Input Status
Data High Byte
8 TB-13C Input Status
1 reserved
9 TB-14 Output Status
2 Protection Status
10 Relay Output Status
3 Fast Current Limit Status
11 Charge Relay State
4 Input TB-1 Status
12 Assertion Level Switch State
5 reserved
13 reserved
6 TB-13A Input Status
14 reserved
7 TB-13B Input Status
15 reserved
9.4
Keypad Status (P531)
When a read command is issued over the LECOM network to Programming Parameter P531 (code number 1531), the
Keypad Status data returned can be interpreted as follows:
Data Low Byte
LOCAL Drive Keypad
0
UP Push-button State
Data High Byte
REMOTE Keypad
8
UP Push-button State
1
DOWN Push-button State
9
DOWN Push-button State
2
MODE Push-button State
10
MODE Push-button State
3
FWD/REV Push-button State
11
FWD/REV Push-button State
4
STOP
STOP Push-button State
12
STOP
STOP Push-button State
5
RUN
START Push-button State
13
RUN
START Push-button State
6
CTRL
CTRL Push-button
14
CTRL
CTRL Push-button
7
Unused
15
Unused