Lenze GSS User Manual
Page 10
Safety instructions
General safety instructions for drive components
l
10
BA 12.0023−EN 7.0
Transport, storage
ƒ
Transport and storage in a dry, low−vibration environment without aggressive
atmosphere; preferably in the packaging provided by the manufacturer.
– Protect against dust and shocks.
– Comply with climatic conditions according to the technical data.
ƒ
Before transport
– Check that all transport locking devices are mounted.
– Tighten all transport aids.
)
Note!
Do not apply extra loads to the product as the transport aids (such as eye bolts
or bearing plates) are designed for the weight of the motor only (refer to the
catalogue for the weight).
}
Danger!
Completely screw in transport aids (such as eye bolts or bearing plates), they
must be flat and applied over their entire surface!
If possible, the transport aids (such as eye bolts or bearing plates) must be
stressed vertically in the direction of the screw axis! Angular tension or tension
to the sides reduces the payload! Observe the information provided in the
DIN 580!
Use additional appropriate lifting aids, if required, to achieve a direction of
loading which is as vertical as possible (highest payload). Secure lifting aids
against shifting!
If you do not install the motor immediately, ensure proper storage conditions.
ƒ
Up to one year:
– Shafts and uncoated surfaces are delivered in a protected against rust status.
Aftertreatment is required where the corrosion protection has been damaged.
– Remove the plug for motors with condensation drain holes (special version).
ƒ
More than one year, up to two years:
– Apply a long−term corrosion preventive (e.g. Anticorit BW 366 from the Fuchs
company) to the shafts and uncoated surfaces before storing the motor away.
(
Stop!
Observe load carrying capacity!
Staying under floating load is prohibited!