Lenze GSS - Manual (Page 63)

Maintenance
Maintenance operations
Table of lubricants
8
l
63 BA 12.0023−EN 7.0
8.2.3 Table of lubricants
)
Note!
Please note that the recommendation of a lubricant/grease or its listing in a
Lenze lubricant table does not mean that Lenze is liable for these lubricants or
damages resulting from incompatibilities of materials used.
The lubricants listed in the lubricant table are permissible for Lenze drives. Specialty
lubricants must be used, for example, for long−term storage or special operating
conditions. These corresponding lubricants are available at a surcharge.
Observe the following legend of the lubricant table for the selection of lubricants!
CLP Þ Mineral oil
CLP PG Þ Polyglycol oil
CLP PAO Þ Synthetic hydrocarbon or poly−alpha−olefin oil
CLP E Þ Diester oil (water pollution class 1)
1) Þ No test results are currently available about the performance of listed lubricants for
worm gearbox lubrication. If these oils are used, the permissible torque must be reduced
to 80% of the catalogue values.
2) Þ Polyglycol oils cannot be mixed with other oil types
3) Þ For ambient temperatures higher than 40°C please contact the manufacturer for exact
ambient conditions!
4) Þ Observe critical starting behaviour for low temperatures! For temperatures lower than
−25°C special measures for the motor storage and NBR shaft seals are necessary!
5) Þ Ambient temperature range
д Ю Food−grade lubricant
` Þ Biodegradable lubricant (lubricant for forestry, agriculture and water supply and
distribution)
d Þ Low−temperature oils, observe critical starting performance at low temperatures!