Lenze SIMPLABELT Compact Units - Manual (Page 15)

Installation
15
L
BA S’belt KE EN 1.0
4 Installation
Caution!
Transport the drive only with transport equipment or hoists which are suitable for this load. Ensure
a safe fixing. Avoid shocks!
The units in Z-design are not stable! Ensure proper support!
4.1 Storage
If you do not install the gearbox immediately, ensure the appropriate storage conditions.
l Up to one year:
Without special measures in dry, dust-free rooms which are protected against sunlight.
– Store gearbox with ventilation so that the breather screw is located at the top.
– Shafts and bright surfaces are delivered with protection against corrosion.
l Remove V-belts when storing the units for more than three months.
l More than a year:
Please contact the factory.
4.2 Installation
4.2.1 Preparation after long storage
Carefully remove the anti-corrosion agents from output shafts and flange surfaces.
4.2.2 General information on the assembly of drive systems
l Take the necessary safety measures prior to any operations:
– Disconnect the machine from the mains, ensure standstill of the machine and avoid any
machine movement.
– Check the proper state of the drive system. Never install and set-up damaged drive
systems.
– Check the combination of drive function and machine function. Check the direction of
rotation.
l The mounting surfaces must be even, without torsion, and free of vibrations.
l Align the drive system on the mounting surfaces exactly with the machine shaft to be driven.
l Ensure that the assembly is without torsion, to avoid additional load.
l Compensate minor misalignment by using suitable flexible couplings.
l Upport the reaction torque appropriately.
l Fixings of accessories and attachments must be secured against loosening.
l We recommend bonding screw connections.
Show/Hide Bookmarks