Lenze EVF9326−xV - Manual (Page 22)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Display elements and function keys
3
l
22 EDKVF93−01 EN 3.0
Displays
0 Status displays of standard device
Display Meaning Explanation
d Ready for operation
c Pulse inhibit is active Power outputs are inhibited
b The set current limit is exceeded in motor or
generator mode
B Speed controller 1 in the limitation Drive is torque−controlled
(Only active for operation with standard
devices of the 9300 series)
A Active fault
1 Acceptance of the parameters
Display Meaning Explanation
p Parameter is accepted immediately Standard device operates immediately with
the new parameter value
SHPRG p Parameter must be acknowledged with T V Standard device operates with the new
parameter value after being acknowledged
SHPRG Parameter must be acknowledged in case of
controller inhibit
T V
Standard device operates with the new
parameter value after the controller is
enabled again
None Display parameter Change is not possible
2 Active level
Display Meaning Explanation
Menu Menu level is active Select main menu and submenus
Code Code level is active Select codes and subcodes
Para Parameter level is active Change parameters in the codes or
subcodes
None Operating level is active Display operating parameters
3 Short text
Display Meaning Explanation
alphanumeric
al Contents of the menus, meaning of the codes
and parameters
In the operating level display of C0004 in % and
the active fault
4 Number
Active level Meaning Explanation
Menu level Menu number Display is only active for operation with
standard devices of the 8200 vector or 8200
motec series
Code level Four−digit code number
5 Number
Active level Meaning Explanation
Menu level Submenu number Display is only active for operation with
standard devices of the 8200 vector or 8200
motec series
Code level Two−digit subcode number
6 Parameter value
Parameter value with unit
7 Cursor
In the parameter level, the digit above the cursor can be directly changed
8 Function keys
For description see the following table