Lenze MC−xxx Card - Manual (Page 23)

Electrical installation
Important notes
4
l
23 BA_MC−Card EN 1.0
4 Electrical installation
4.1 Important notes
(
Stop!
Short circuit and static discharges
The printed circuit board and the standard device contain components which
are endangered in the case of short circuit or static discharge.
Possible consequences:
ƒ The printed circuit board or devices connected are destroyed.
Protective measures:
ƒ For all operations on the printed circuit board, the latter as well as the
standard device have to be in a deenergised state. This in particular applies
to the connection/disconnection of the printed circuit board and the
connection/disconnection of connectors.
ƒ All persons handling printed circuit boards must regard ESD measures.
ƒ Connector contacts must not be touched.
ƒ Printed circuit boards must only be touched in contact−free places and must
only be placed on suitable bases (e. g. on ESD packaging or conductive
foamed material).
ƒ Printed circuit boards must only be transported and stored in ESD
packaging.
)
Note!
For mounting the unit, the housing of the industrial PC has to be opened
(
^ documentation for the standard device).
4.2 Mounting
SPEED
MC-ET H
RJSS -5381 RJSS-5381
SPEED
LINK
LAN
MC-ET H
RJSS -5381 RJSS-5381
 ‚
ƒ
ACTI VE
LINK
PROFI NET
MC-PNx
RJSS -5381 RJSS-5381
RJSS -5381 RJSS-5381
SYS ST0 ST1 ST2
LINK
LAN
ACTI VE
LINK
PROFI
NET
MC-PNx
RJSS -5381 RJSS-5381
RJSS -5381 RJSS-5381
SYS ST0 ST1 ST2
MC−PNx−002