Lenze Tmd Series Drives Modbus Communications - Manual (Page 22)

RG-TDMOD 18
Drive Control & Communication
5.5.7 Present Fault - Registers #24 & 29
Table 16 lists the Present Fault (Register #24 byte D6H of Register #29 DH)
Table 16: Present Fault
Setting Fault Display Setting Fault Display
0 NO FAULT 18 INTERNAL FAULT 1 (EPM) F1
1, 2 OUTPUT (TRANSISTOR) FAULT OC1 19 INTERNAL FAULT 2 F2
3 EARTH FAULT OC2 20 INTERNAL FAULT 3 F3
4 RESERVED 21, 22 INTERNAL FAULT 5 F5
5 OVER TEMPERATURE FAULT OH 23 INTERNAL FAULT 6 F6
6 FLYING RESTART FAULT rF 24 INTERNAL FAULT 7 F7
7 OVER VOLTAGE FAULT OU 25 INTERNAL FAULT 8 F8
8 UNDER VOLTAGE FAULT LU 26 INTERNAL FAULT 9 F9
9 MOTOR OVERLOAD FAULT OC6 27 IDENTIFICATION FAULT bF
10 OEM DATA FAULT GF 28 A/D CONVERTER FAULT Ad
11 CONFIGURATION FAULT CFG 29 REMOTE KEYPAD FAULT JF
12 DYNAMIC BRAKE OVERHEATED FAULT dF 30 LOSS OF 4-20mA SIGNAL Sd5
13 SINGLE PHASE FAULT SF 31 COMMUNICATION FAULT FC5
14 EXTERNAL FAULT EEr 32 INTERNAL FAULT 4 F4
15 CONTROL FAULT CF 33 LOSS OF MOTOR PHASE LP1
16 AUTOMATIC START INHIBITED LC 34 INTERNAL FAULT 10 Fo
17 INCOMPATIBILITY FAULT cF
5.5.8 Commanded Rotational Direction - Registers #24 & 29
Table 17 lists the Commanded Rotational Direction (Register #24 byte D6L or Register #29 DL)
Table 17: Commanded Rotational Direction
Setting Direction
0 FORWARD
1 REVERSE
5.6 Motor Volts - Register #30
Output Voltage to the motor is expressed in volts (V). It is not expressed as a percentage of the nominal
drive voltage.