Lenze Tmd Series Drives Modbus Communications - Manual (Page 28)

RG-TDMOD 24
Drive Control & Communication
Parameter No.
1 Tmd Register #
(hexadecimal
representation)
Parameter Name Range of Adjustment
Modbus value (decimal value)
Factory
Default
PV503
c11 120 (78H) Configuration
Analog Output (62) 0 None
1 Output frequency 0 - 10V
2 Output frequency 2 - 10V
3 Load 0 - 10V
4 Load 2- 10V
5 Dynamic Braking 0
c17
c18 121 (79H)
122 (7AH) Configuration Digital Outputs
(A1, A2) 0 Ready
1 Fault
2 Motor is running
3 Motor is running - CW rotation
4 Motor is running - CCW rotation
5 Output frquency = 0Hz
6 Frequency setpoint reached
7 Threshold (C17) exceeded
8 Current limit reached c17 = 0
c18 = 1
c20 123 (7BH) I 2 T Switch-Off 30 - 100% 100%
c25 124 (7CH) LECOM Baud Rate 0 (9600, 8, N, 2 if C01 = 8...11)
1 (9600, 8, N, 1 if C01 = 8...11)
2 (9600, 8, E, 1 if C01 = 8...11)
3 (9600, 8, O, 1 if C01 = 8...11) 0
125 (7DH) Not Used
126 (7EH) RESERVED
c40 127 (7FH) Freq. Setpoint Command 0 - 2400 (0.0 - 240 Hz) 0.0 Hz
c42 128 (80H) Start Condition 0 Start after LOW-HIGH change at 28
1 Auto Start if 28 = HIGH
2 Flying restart (auto start disabled)
3 Auto Start if 28 = HIGH, with flying restart 1
c43 129 (81H) Flying Restart Selection 0 Search range: C11 ... 0Hz
1 Search range: last frequency ... 0Hz 0
130 (82H) Not Used
c48 131 (83H) Motor Auto-Calibration 0 Calibration not done
1 Calibration enabled
2 Calibration complete Read Only
132 (84H) Not Used
c60 133 (85H) Mode Select for c61 0 Monitor Only
1 Monitor and Edit 0
c61 134 (86H) Present Fault Status / Error Message (refer to Note 5) Read Only
c62 135 (87H) Last Fault Error Message (refer to Note 5) Read Only
c63 136 (88H) Last but one Fault Error Message (refer to Note 5) Read Only
c64 137 (89H) Last but two Fault Error Message (refer to Note 5) Read Only
1 = The drive's programming code number; (2) = Two decimal places assumed.