Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 376)

L-force | PLC Designer
The Resources
374 DMS 3.2 EN 02/2011 TD29

Base parameters of a CAN module
The Base parameters dialog of a CAN module matches that of the other modules (see
'Base parameters of an I/O Module'Chapter Base parameters of an I/O Module).
IEC addresses by which the PDO’s (Process Data Object) in the project can be
addressed are entered for output and input addresses, whereby the direction (input or
output) is defined from view of the module.
A marker address must be given at the diagnostic address of the CAN module. It works
like described for the CAN master.
CAN parameters of a CAN Module
CAN parameters Dialog for a CAN Module
The CAN parameters of a CAN module, which is not acting as master (global watching
of the bus), are different to those of a CAN master.