Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 589)

L-force | PLC Designer
Compiler Errors and Warnings

DMS 3.2 EN 02/2011 TD29 587
3453
"The channel '<name>' couldn't be created!"
The device file for channel <name> does not fit to the current configuration.
Eventually it has been modified since the configuration has been set up in »PLC
Designer« or it is corrupted.
3454
"The address '<name>' points to an used memory!"
Option 'Check for overlapping addresses' is activated in the dialog ‚Settings’ of the PLC
configuration and an overlap has been detected. Regard, that the area check is based
on the size which results of the data types of the modules, not on the size which is
given by the entry ‚size’ in the configuration file.
3455
"Error during load: GSD-File '<name>' could not be found, but is referenced in
hardware configuration!"
Eventually the device file required by the Profibus configuration is not in the correct
directory. . Check the directory setting for configuration files in ‚Project' 'Options'
'Directories'.
3456
"The profibus device '<name>' couldn't be created!"
The device file for module <name> does not fit to the current configuration.
Eventually it has been modified since the configuration has been set up in »PLC
Designer« or it is corrupted.
3457
"Error in module description!"
Please check the device file of this module.
3458
"The PLC-Configuration couldn't be created! Check the configuration files."
Check if all required configuration and device files are available in the correct path
(see defined compile directory in 'Project' 'Options' /Directories)