MK Diamond MK-370 - Manual (Page 14)

14
MK-370 SAW INSTALLATION
(D)
Align the Cutting Head Retaining
Holes to the holes on the Post
Follow the assembly instructions to prepare your MK-370 for operation.
CUTTING HEAD INSTALLATION
(B)
Remove the Blade Guard
Wingnut and then remove
the Blade Guard
(A)
Loosen the Blade Guard
Retaining Knob
(C)
Locate and remove
the three Cutting Head
Retaining Screws using a
Phillips Screwdriver
(B)
Loosen the Blade Guard
Retaining Knob and open
the Blade Guard
(A)
Loosen the Blade Guard
Retaining Wingnut
(C)
Place the Shaft Wrench on the Motor
Shaft (NOTE: the Outer and Inner Flanges
and the Blade Nut are removed in the
photo above) rotate blade shaft so shaft
wrench is engaged.
DIAMOND BLADE INSTALLATION
When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw. NOTE:
(E)
Install the three Cutting Head
Retaining Screws using a Phillips
Screwdriver
(F)
Install the Blade Guard and
tighten Wingnut and Retaining
Knob