MK Diamond MK-370 - Manual (Page 17)

17
WATER PUMP PREPARATION
(B)
Connect the Cooling Transfer
Tube to the inlet connection
of the Blade Guard
(A)
Press the end of the cooling
Transfer Tube onto the Water
Pump
(E)
Verify the Movable Cutting
Table moves freely
(D)
Inspect the MK-370 for
damage – ensure the cord is
free of cracks or cuts
(D)
Fill the water Pan with
clean water covering Pump
suction (this should be done
periodically during cutting)
(E)
Connect the Water Pump
power cord to the connection
found on the back of the motor
MK-370 SAW ASSEMBLY
(C)
Place the Water Pump in the
Water Pan with the suction down
and insert the Pump Cord to the
clip in the back.