Mk-370 saw troubleshooting – MK Diamond MK-370 User Manual
Page 26
Advertising
26
MK-370 SAW TROUBLESHOOTING
BLADE STOPS TURNING
(A)
Check the ON/OFF Switch is in
the ON position
(B)
Verify all plugs are fully connected.
Check to see if the wall outlet
Ground Fault Circuit Interrupter
(GFCI) is tripped.
(C)
Verify circuit breaker not
tripped; if it is tripped, reset it
once only
(D)
Check power source voltage
is 120v - if not 120v, move to
another circuit
Advertising