MK Diamond MK-1280 Gas User Manual
Page 25
25
Perform the following maintenance every year.
YEARLY MAINTENANCE
Refer to Engine Manual
1. Replace engine Air Filter. Refer to Engine Manual
2. Replace Spark Plug. Refer to Engine Manua
l
3.
Check/Adjust Idle Speed Check/adjust Valve Clearance. Refer to Engine Manual
4. Inspect Micro-V Belts.
TWO-YEARLY MAINTENANCE
1. Check Fuel Line. Refer to Engine Manual
Fig. C
Open the Cooling Flow Con-
trol Valve and adjust flow
Fig. D
Verify cooling flow exists on
both sides of the blade
Fig. E
Move the Throttle Lever to
adjust blade seed
Like most cutting instruments, a diamond blade performs best when it is dressed. Over time and
use, diamonds on the outer edge will become smoothed or “glazed” over. This will reduce grinding
efficiency and may cause the blade to “wander” or bend giving the illusion of an alignment problem.
When this occurs, the blade will need to be dressed. The diamond blade can be dressed using the
MK Dressing Stick (part number 152792) and by following the steps below.
BLADE DRESSING
Skip Steps C and D if cutting dry.
NOTE:
Fig. A
Setup MK-1280 Gas Saw for
operation (See Setup, Startup,
Adjustment Operation)
Fig. B
Position the Dressing Stick
Fig. F
Cut the Dressing Stick 7 or 8
times to dress the Blade. Turn
off engine
MK-1280 GAS SAW
MAINTENANCE