MK Diamond MK-1280 Electric - Manual (Page 19)

19
MK-1280 ELECTRIC SAW STARTUP
Fig. A
Attach Vacuum Hose to
Vacuum Port
DRY CUTTING
Skip step C, if cutting dry.
CUTTING
NOTE:
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which
it was designed.
CAUTION
Fig. A
Set the Adjustable Cutting
Guide
Fig. B
Position the masonry piece
Fig. E
Slowly push piece toward the
blade – continue until the
cut is complete
Fig. F
Turn motor OFF when work is
complete
Fig. D
Setup to Cut. Start
saw
Fig. C
Open the Cooling Flow Control
Valve and adjust flow. Verify cooling
flow exists on both sides of the blade