MK Diamond MK-2000 Electric - Manual (Page 27)

27
Angle Cuts may be performed by using any cutting method. The following example uses the Step Cut
method.
Cut in smooth even strokes; do not force the saw to cut.
MK-2000 ELECTRIC SAW OPERATION
CAUTION
(A)
Reposition the adjustable Cutting
Guide to the 45° cutting position
(B)
Position the masonry piece and ad-
justable Cutting Guide to the desired
cut length. Tighten thumbscrew.
(C)
Turn ON machine. Open the Cool-
ing Flow Control Valve and adjust
cooling flow. Verify cooling flow ex-
ists on both sides of the blade.
(D)
Hold the masonry piece, lower
the Cutting Head and “push” the
piece toward the Blade. Lower
1/4" - 1/2" for "push" stroke.
(E)
Once the “push” cut is complete,
lower the Cutting Head further and
“pull” the piece back into the blade.
Turn OFF saw when cut is complete.
Skip steps C and D, if cutting dry.
ANGLE CUTS
NOTE:
Repeat steps E and F until cutting is complete. Turn off machine.