MK Diamond MK-3000 Series - Manual (Page 20)

20
MK-3000 SERIES INSPECTION & START-UP
PRE-OPERATION CHECKLIST
WARNING
Before leaving our factory, every machine is thoroughly tested. Follow instructions strictly and your
machine will give you long service in normal operating conditions.
1. Check engine oil. See Engine Owner’s Manual for type & quantity.
2. Connect battery cables.
3. Check hydrostatic transmission fluid level.
4. Check the engine air cleaner.
Machine Cold
Before starting up the machine, make sure you read this entire Operation Manual and are
familiar with the operation of the machine.
1. Check the engine air cleaner hose clamps. Tighten as required.
2. Tension the blade drive V-belts. DO NOT overtension.
SCHEDULE MAINTENANCE QUICK REFERENCE
1-2 Hour Operation Checklist
WARNING
ALWAYS locate machine on a level surface with the engine “OFF” and the ignition switch set in the
“OFF” position before performing any maintenance. Let the machine cool down prior to any service.
Ensure the parking brake is set.
WARNING
Before performing any maintenance, ALWAYS locate machine on a level surface with the engine
“OFF” and the ignition switch set in the “OFF” position.
1. Check engine oil level.
2. Check blade guard for damage.
3. Check hoses and clamps for damage or looseness. Tighten or replace as necessary.
4. Check air cleaner for restriction. Replace at regular intervals air filters.
Service Daily
See the Maintenance Schedule Table on Page 25.
Other time interval service