MK Diamond MK-3000 Series - Manual (Page 23)

23
MK-3000 SERIES OPERATION
NOTICE
Read the engine instructions manual before starting.
1. Check engine oil. Add oil if low.
2. Check fuel level. Add fuel if low.
3. Check cooling air intake areas and external surfaces of engine. Make sure surfaces are clean
and
unobstructed.
4. Check that air cleaner components and all shrouds, equipment covers and guards are in place
and securely fastened.
WARNING
Be sure blade is unobstructed and not resting on ground.
WARNING
Be sure hands and feet are clear of blade.
STARTING ENGINE
STARTING INSTRUCTIONS
1. Verify that E-Stop is pulled out.
2. Place FNR handle in NEUTRAL. Engine will not
start unless FNR handle is in neutral.
3. Verify the transmission is in NEUTRAL.
Engagement handle in unlocked and fully down position.
4. Pull throttle handle out half-way.
5. Close choke by pulling choke button to full out position.
6. Start engine by rotating starter switch to the right.
NOTICE
DO NOT crank engine for more than 30 seconds at a time. If engine fails to start, wait about 2 min-
utes between cranking periods to prevent starter from overheating.
NOTICE
Allow engine to warm up at least 3 minutes before applying load.
NOTICE
If the engine has been running hard and is hot, do not shut engine off abruptly. Cool engine by re-
moving load and allowing engine to run idle for 3 to 5 minutes.
7. After engine starts, push choke button in as required for smooth running.
8. When engine is warm, pull throttle out to maximum.
9. To stop engine, push throttle to idle, rotate ignition switch to “OFF” position.
Fig. 14 Pull Engagement Handle
Engagement
Handle
FNR
Handle