MTS Series 609 Alignment Fixture - Manual (Page 26)

Series 609 Alignment Fixture Product Information 26 Installation
E. Install the force transducer and alignment fixture assembly into the
crosshead. Carefully lower the crosshead so that the mounting stud
goes through the crosshead.
F. Screw the preload collar or nut onto the mounting stud. Tighten the
preload collar or nut until the alignment fixture is snug against the
crosshead. Ensure that the 0° mark remains facing to the front of the
load unit.
4. Check the alignment of the force transducer and alignment fixture assembly.
If your load unit manual includes a procedure to align the force transducer,
skip this step and complete the alignment procedure in your load unit
manual.
If not, complete the following procedure:
A. Position the actuator at midstroke.
B. Move the crosshead so that there is about 360 mm (14 in) between the
top of the actuator and the bottom of the force transducer. Lock the
crosshead.
Alignment takes place in a crush zone with hydraulic pressure on.
Hands can be crushed and equipment can be damaged equipment when
hydraulics are turned on.
Be careful when working in a crush zone.
C 0
A 0
Force Capacity
A0
WARNING