MTS Model 494-05 Handset - Manual (Page 25)

Handset Control Procedures
MTS Model 494.05 Handset 25
7. When you are finished positioning the actuator, press (Manual
Command) to exit Manual Command.
How to Control Hydraulics
There is a Hydraulics Control (HC) page for each HPU and HSM. The top line in
the display identifies the name or the HPU/HSM resource as defined in the
system .hwi file.
1. On the handset, press (Exclusive Control).
2. Use the (Page Forward) or (Page Back) keys to display the
Hydraulics Control (HC) page.
The > symbol shows the active state.
3. If necessary, press (Reset/Override) to override any interlocks.
Note A station interlock prevents an HSM start, but permits an HPU start. The
HSM is a station resource and cannot start when a station interlock is
active. An HPU is considered an external device and can be started with
an active station interlock (even if it has caused the interlock).
Applying hydraulics can result in sudden actuator motion.
A moving actuator can injure anyone in its path.
Always clear the actuator area before applying hydraulics.
*HC SN1 HSM1 T2=J28B
> Off
- Low
High
WARNING