MTS SWIFT 45 GLP Sensor - Manual (Page 33)

Road and Track Vehicles
SWIFT ® 45 GLP Sensors Installation 33
Road and Track Vehicles
Equipment required
This procedure requires two people. To install the SWIFT 45 GLP sensor, you
will need the following equipment:
• Hub adapter
• Modified rim (see next figure)
• Anti-rotate assembly (including customer-supplied mounting arm)
• Small set of metric hex-head wrenches
• Tube bender for the restraint tube
• Tube cutter
• Metric socket head drive set (up to 17 mm) with extension
• Molykote g-n paste, 2.8 oz. tube (MTS part number 011-010-217)
• Nikal based anti-galling compound (MTS part number 011-354-902)
• Transducer mounting bolts (per transducer)
– M20 x 1.5 mm (quantity 8)
– M12 x 1.75 mm (quantity 8; length is dependant on the thickness of the
rim flange)
– M12 x 1.75 mm (quantity 32; length is dependant on the thickness of
the spindle adapter spacer)
– lug nuts, shim washers, and washer plates
• For dual rims
– M20 x 1.5 mm (quantity 8)
– M12 x 1.75 mm (quantity 8; length is dependant on the thickness of the
rim flange)
– M12 x 1.75 mm (quantity 32; length is dependant on the thickness of
the spindle adapter spacer)
– lug nuts, shim washers, and washer plates
– slip ring extension assembly
– M12 x 1.75 mm x 30 mm long bolts (quantity 4)
• Slip ring assembly fasteners
– M5 x0.8 mm bolts (quantity 8)
• Torque wrenches, capable of the following ranges:
– 2.3–23 N·m (20–200 lbf·in)
– 24–74 N·m (18–55 lbf·ft),