MTS SWIFT 45 GLP Sensor - Manual (Page 57)

Road Simulator
SWIFT ® 45 GLP Sensors Installation 57
8. Attach the connector housing (or the slip ring bracket and slip ring) to each
transducer.
9. Attach the appropriate cables from the connector housing or one cable from
the slip ring to the TI or data acquisition.
A. Secure the cables to the lateral strut of the road simulator so that it will
not become damaged during testing.
Be sure to leave enough slack for the full range of movement of the
simulation fixture.
10. Connect the power supply to the TI.
You might need to first convert from 120 or 240 V AC to 10–28 V DC.
11. Connect the six data cables from the TI to the data recorder or your test
control system.
There is one cable per channel of data from the TI to the data recorder.