MTS WIFT Mini Transducer Interface - Manual (Page 28)

SWIFT ® Mini TI 28
Transducer Interface
Hardware Overview
TI Rear Panel
Transducer Interface Rear Panel
J1 Power connector
Connect a power cable from the external power source.
J2 Output connector
The J2 Output connector provides the conditioned sensor outputs that can be
connected to a data acquisition or test control system.
J3 Transducer
connector
Connect the data cable from the transducer slip ring to the Transducer Connector.
Transducers Designed
to Operate with a Low-
Profile TI but Using a
Mini TI
For SWIFT transducers designed to operate with a Low-Profile TI but are using
the Mini TI, an adapter cable is needed; MTS part number 100224052. The
transducer and shunt cables are connected to one end of the adapter cable and the
other end is connected to J3 of the Mini TI.
J3 Transducer
Connector J2 Output
Connector J1 Power
Connector