MTS WIFT Mini Transducer Interface - Manual (Page 46)

SWIFT ® Mini TI 46
Select a Zero Method
Transducer Interface Setup
Items you may edit
• OutputPolarities—defines the polarities of the six outputs. Change these
only if your application requires different polarities from those identified on
the transducer label.
• AngleMode—selects the mode used for determining the encoder sine and
cosine.
• AngleFixed—used for non-spinning applications.
• AngleOffset— used for spinning applications. Normally you do not need to
change this value.
• EncoderSize—defines the size of the encoder.
• Y-Axis Offset—shifts the output coordinate system along the y-axis
• Output 7 signal—selects Angle of Angular Velocity for analog output
channel 7.
• VelocityFullscale—sets the 10 V fullscale value for the Angular Velocity
output.