MTS WIFT Mini Transducer Interface - Manual (Page 42)

SWIFT ® Mini TI 42
USB Driver Installation
Transducer Interface Setup
USB Driver Installation
Two USB 2.0 drivers must be installed to recognize the Transducer Interface.
Perform the following procedure to install these drivers on a laptop or desktop
computer that does not already have these drivers installed.
Important Do not allow Windows to search for or choose the drivers for you.
Always direct Windows to the path containing the Mini TI USB
drivers.
1. Copy the Mini TI USB drivers from the Utilities CD provided to your hard
drive.
2. Push and hold the Power button on the Mini TI. Release the button when
the Power indicator lights.
All the indicators on the Mini TI will light briefly then go out leaving only
the Power indicator lit.
3. Connect the USB cable between the computer and the Mini TI.
The Found New Hardware Wizard will launch. On the screen that
displays, select the No, not this time radio button (see the next figure).