MTS WIFT Mini Transducer Interface - Manual (Page 33)

TI2XFER - Transducer Interface Transfer
SWIFT ® Mini TI Software Utilities 33
TI2XFER - Transducer Interface Transfer
This program is used to read the current settings in the TI and save them to the
computer (upload) or write the values from a calibration file on the computer to a
TI (download).
Syntax
ti2xfer
The following is an example of the ti2xfer command:
Example
File Format
The file used with commands contains a header and version number, and a list of
parameters. Transducer calibrations can be uploaded and saved individually. If a
test needs to be rerun at a later date but the original transducer is not available,
another transducer can be used by downloading its calibration information.
Following the header is a list of parameter settings. The syntax is:
ParamName=ParamValue
The following rules apply:
Tabs and spaces are allowed.
The parameters can occur in any order.
Names are case insensitive. If a parameter name is not recognized, a
warning will be reported.
If an error causes the program to abort while downloading, any parameters
prior to the error will have been successfully downloaded because
parameters are downloaded as they are read. Only those parameters in the
file are downloaded. Parameters not in the file are unchanged.
C:\bin>ti2xfer
SWIFT Mini TI transfer (Version 1.0)
Upload and download settings
0...Exit
1...Upload settings from TI box
2...Download settings to TI box
Choice? 1
Filename? sample.cal
0...Exit
1...Upload settings from TI box
2...Download settings to TI box
Choice? 0