Multiquip P54K-K2B-K4B - Manual (Page 28)

26 P54
K/K2B/K4B
Operation :
5.6 Driving operation :
The machine is set in motion by actuation of the drive pedals.
When actuating the left-hand drive pedal, the machine travels in reverse, when actuating the
right-hand drive pedal, the machine travels forwards.
The speed can be steplessly adjusted depending on pedal deflection. (Fig. 6, 7)
______________________________________________________________________________________
_________
5.7 Vibration :
Machine vibration is switched on using the rocker switch "VS". (Fig. 4, Page 20)
Remark :
• Machines which are equipped with a pusher blade can only perform
compaction work with the blade in the raised position
• Simultaneous levelling and compaction is not possible.
Important : • All compaction work may only be performed at maximum
engine speed!
Danger :
During compaction work near buildings or structures, check the effects
on neighbouring structures and if necessary discontinue the work.
______________________________________________________________________________________
5.8 Actuation of the pusher blade :
The pusher blade is actuated using control lever (Fig. 5, Page 19).
1. Control lever back : Lift pusher blade
2. Control lever forward : Lower pusher blade
3. Control lever left : Pusher blade turns to the left (tilt device)
4. Control lever right : Pusher blade turns to the right (tilt device)
5. Control lever to position "FLOAT" : Pusher blade float position
(during reverse travel to smooth the terrain)
Remark :
The pusher blade must be rested on the floor every time before switching off the engine.
Danger :
Persons may not be transported on the pusher blade
Movement of other vehicles with the aid of the pusher blade is prohibited.