Multiquip P54K-K2B-K4B - Manual (Page 40)

38 P54
K/K2B/K4B
Maintenance :
8.14 Adjusting the stripper
• Release all four screws at the stripper holder "ASH" and
push the stripper towards the facing.
• The distance between the stripper and the facing must be at
least 2 mm at every point
• Tighten the screws again. (Fig. 41)
Remark :
In case of stripper wear, the stripper must be readjusted or replaced.
______________________________________________________________________________________
8.15 Radiator :
The radiator of the diesel engine must be filled at all
times up to the lower edge of the filling nozzle.
(Fig. 42) The rollers are supplied ex works with an anti-freeze
agent for protection to as low as –25°. The radiator may only be
operated with suitable anti-freeze in the cooling water.
In case of repair work, the cooling water can be drained off
using a drainage tap located on the underneath of the radiator.
Danger
Danger of scalding due to hot water or steam.
Work at the radiator may only be performed when the
machine has cooled down
Note :
Ensure safe, environmentally compatible disposal of fuels and operating
media as well as exchange parts.
Fig.41
Fig. 42