Multiquip P54K-K2B-K4B - Manual (Page 29)

27 P54
K/K2B/K4B
Operation :
5.9 Switching off the machine
1. Move the gas lever to the "Stop" position. (Fig. 8, Page 20)
2. Before switching off, allow the engine to run for a brief period at idle speed to equalize
the temperature.
3. Switch the ignition key to the "0" position. (Engine - Stop) (Fig. 4, Page 19)
Note :
Before switching off the engine, align the machine straight in order to permit simpler
mounting and descent.
After switching off the machine, pull out the ignition key. The cover over the
instruments must be closed in order to protect the machine from damage or
vandalism.
The pusher blade must be lowered to the ground before switching off the engine.
When switching off the machine on slopes, always safeguard using chocks.
______________________________________________________________________________________
6.0 Setting the driver's seat :
Danger :
It is strictly prohibited to set the driver's seat while driving.
Danger of accidents!
In the case of machines with rollover bar or ROPS roof, always wear your seat
belt before starting the machine.
Operation :
Adjusting lever VH1 : Set the machine operator's body weight!
(on the right next to the adjusting lever is a scale for setting
the weight) (Fig. 20)
Adjusting lever VS2 : Set the seat springing! (Fig. 21)
(stiff - medium - light)
Remark :
Underneath the driver's seat is a limit switch, which is actuated by the weight of the
machine operator. The adjusting lever VH2 for the seat springing must not be set too
stiff, otherwise the limit switch is not actuated.
Result : Machine cannot be started
Remedy : Choose a less stiff seat setting
Fig. 21
Fig. 20
VH1
VS2
VS3
VS4