NTi Audio Digirator DR2 - Manual (Page 20)

Operation
20
Setting the parameters
You have two possibilities for setting up the parameters of the
test signals. Use either the direct buttons or the rotary wheel.
Setting parameters using the direct access buttons
1. Press the “level” or “freq” button.

You have selected the desired parameter.
2. Turn the rotary wheel to set the parameter.
3. Confirm the setting with the “Enter” button.

You have now set up the parameter.
Setting parameters using the rotary wheel
1. Turn the rotary wheel.

The selected parameters will be marked with a black bar.
2. Confirm your choice with the “Enter” button.

The parameter display blinks.
3. Turn the rotary wheel to set the parameter.
4. Confirm the setting with the “Enter” button.

You have now set the parameter.