NTi Audio Digirator DR2 - Manual (Page 49)

49
Trouble Shooting
9. Tips and Trouble Shooting
Faults and their correction
Fault Fault finding Cause Remedy
The DR2 does not generate
an output signal. „mute“ button blinks. You have switched the
instrument to Mute. Press the “mute” button.
“mute” button lights up
continuously. You have called up the “Pink
Noise” (PNoise) test signal or
you are in the Pause cycle of
the Chirp test signal. Wait until the pause has
ended.
Press the “Start” button.
Cable not plugged in correctly
or mis-wired. Plug in the cable correctly and
check pin wiring.
Screen contrast poor. Contrast needs to be
adjusted. Press “esc” and operate the
rotary switch to set the
contrast.
Wave Files, DTS or Dolby
Wave files are not
played back. “mute” button lights up
continuously. You have loaded a non-sup-
ported Wave format. Load a supported Wave
format (see page 36).