Omnitron Systems Technology iConverter 2FXM User Manual - Manual (Page 27)

4.2 MODULE MANAGEMENT MODE
From the Module configuration screen, the management mode can be changed. Select option 18 to change
the mode. The management mode options will be displayed.
PI
Module - iConverter 2FXM iConverter, Serial Agent
Identifier -
Chassis Number = 1 Switch ON condition OFF condition H/W Actual
Slot Number = 11 1: Pause Enabled Pause Disabled Off Off
Model Number = 8959-0 2: Port 1 HDX Port 1 FDX Off Off
3: Not Available
Serial Number = xxxxxxxx 4: Not Available
Manufacturing Date = xxxxxxxx 5: Port 2 HDX Port 2 FDX Off Off
Product Revision = xx 6: Link Propagate Link Segment Off Off
Software Revision = xx 7: Remote Fault Normal Off Off
8: Symm Fault Det Normal Off Off
LED 9: BP A Enabled BP A Disabled Off Off
1: Power = On 10: BP B Enabled BP B Disabled Off Off
2: Power Supply 1 = Off 11: Not Available
3: Power Supply 2 = Off 12: Slave Only Master/Slave Off Off
4: Power Supply 3 = Off 13: Not Available
5: Port 1 Link = Off 14: Not Available
6: Port 1 FDX = Off 15: Not Available
7: BP Master = Off 16: Not Available
8: Port 2 Link = Off OAM settings:
9: Port 2 FDX = Off 17: IP protocol State On
18: Management Mode Secure OAM
Toggle Switch(1-16), (I)dentifier, (R)eset, (H)elp, (P)ortStat, Port(C)tl >
Mode (1=OAM Off, 2=Auto Secure OAM, 3=Auto ah OAM, 4=Secure OAM, 5=ah OAM): 3
The 2FXM module supports several management options. Option 18 configures how the module will
communicate to its remote partner. ‘Auto Secure OAM’ (option 2) and ‘Secure OAM’ (option 4) uses
Omnitron’s proprietary secure encrypted management channel. ‘Auto Secure OAM’ will force the remote
partner to communicate using the Secure OAM protocol while ‘Secure OAM’ will only attempt to
communicate with the remote partner over the secure protocol. The management channel can support IP or
IP-less connectivity based on the configuration of the ‘IP Protocol State’, option 17. ‘Auto ah OAM’
(option 3) and ‘ah OAM’ (option 5)’ conforms to the IEEE 802.3ah specification. ‘Auto ah OAM’ will
force the remote partner to communicate using the ah OAM protocol while ‘ah OAM’ will only attempt to
communicate with the remote partner over the ah protocol. This option provides an industry standard
method of fault detection and monitoring. The management channel supports both IP and IP-less connectivity
based on the configuration, option 17 and 18.
NOTE: See NetOutlook User Manual for complete information on the management modes.
Page 27