Omnitron Systems Technology iConverter 2FXM User Manual - Manual (Page 4)

2.0 PORT STRUCTURE
2.1 OVERVIEW
The front panel of the 2FXM provides access to the management (serial console) and fiber ports. The
fiber ports are SFP supporting 100BASE-FX transceivers. The plug-in module features two additional
Ethernet ports for connectivity via the chassis backplane.
2.1.1 Management Port
PI SA
The 2FXM features a Serial RS-232 Console Port (aka Craft Interface) which can be connected to a computer
for initial setup and configuration. The Serial Console Port is accessed through the mini DIN-6 female
DCE interface. Connect the interface to a computer’s DB-9 serial port using the mini DIN-6 male to DB-
9 female cable adapter (Part # 8082-0), which is included with the 2FXM.
An optional DB-9 male to female straight-through serial cable is available for extension (Part # 8081-3).
2.1.2 Fiber Ports
PI SA
The fiber interface supports the 100BASE-FX protocol. The fiber interface operates in manual mode and
supports half or full duplex operation. The fiber port can be enabled or disabled via network management.
A port disabled with the Port Access Control feature will still connect and allow 802.3ah OAM or IP-less
(secure) OAM communication, but blocks normal data traffic.
2.1.3 Backplane Ethernet Ports
PI
The plug-in module supports two additional 10/100Mbps Ethernet Backplane Ports. The Backplane Ports
A and B allow Ethernet data connectivity between adjacent modules in an iConverter chassis. The two
backplane ports can be disabled or enabled via a DIP-switch or network management.
The iConverter 19-Module, 5-Module, 2-Module and 1-Module Redundant Chassis backplanes provide
ethernet data connectivity between adjacent slots or ports. The A and B backplane ports connect the slots
as illustrated.
Page 4