Omnitron Systems Technology iConverter 2-Module Power Chassis User Manual

Page 9

Advertising
background image

Page 9

3.4 DC Powered Chassis Mounting

Locate the DC circuit breaker of the external power source, and switch the circuit

breaker to the OFF position.

Prepare a power cable using a three conductor insulated wire (not supplied) with a

14 AWG gauge minimum. Cut the power cable to the length required.

Strip approximately 3/8 of an inch of insulation from the power cable wires.

Connect the power cables to the

iConverter

Chassis by fastening the stripped ends

to the DC power connector.

WARNING: Note the wire colors used in making the positive, negative and ground

connections. Use the same color assignment for the connection at the circuit breaker.

Connect the power wires to the circuit breaker and switch the circuit breaker ON. If

any modules are installed, their Power LED should indicate the presence of power.

Fig. 7 Rear of 2-Module Chassis with DC Power Connector

NEVER ATTEMPT TO OPEN THE CHASSIS OR SERVICE THE
POWER SUPPLY OR FAN MODULE. OPENING THE CHASSIS

MAY CAUSE SERIOUS INJURY OR DEATH.

THERE ARE NO USER REPLACEABLE OR SERVICEABLE

PARTS IN THIS UNIT.

WARNING!!!

Advertising