Omnitron Systems Technology Cable Management Kit for 5-Module Chassis - Manual

Product Overview
The
iConverter Cable Management Kit organizes the routing of fiber and copper cables
providing a secure, clean and orderly installation. The Cable Management Kit is used with
the iConverter 5-Module Chassis.
Cable Management Kit consists of the following items:
• Cable Tray with six cable clips
• Two extended L-shaped mounting brackets with eight 1/4” 4-40 flat head machine screws
• Four rack mounting screws 1/2” 10/32 truss head machine screws
• 23” mounting bracket (included with the 8096-2 kit only)
Installation Procedure
1) Install/Remove Cable Clips
2) Install Extended L-Shaped Mounting Brackets
3) Install Cable Management Tray
4) Cable Management Tray Operation
1) INSTALL/REMOVE CABLE CLIPS
To install the Cable Clips on the Cable Tray, push the pin located on the bottom of the Cable
Clip into the hole on the Cable Tray until the pin is fully inserted.
To remove the Cable Clips, pinch the barbs on the pin located on the bottom of the Cable
Clip and pull up on the Cable Clip. 040-08096-001 5/14
Page 1
Omnitron Systems Technology * 38 Tesla * Irvine, CA 92618
949-250-6210 tel * www.omnitron-systems.com
iConverter Cable Management Kit
Installation Guide
Installation Procedure for 23” Rack Mount
The
iConverter Cable Management Kit (8096-2) provides equipment installation to 23 inch
equipment racks. 23” mounting brackets are included to extend the Cable Tray and 5-Module
Chassis to accommodate the 23” equipment rack as illustrated in Figure 5.
Figure 5: 23” Mounting Bracket Installation
Install the extended L-shaped mounting brackets to the 5-Module Chassis per Step 2.
As illustrated in the figure above, the 23” mounting bracket is installed on the back side of
the extended L-shaped mounting brackets.
Install the 23” mounting bracket to the equipment rack. Install the Cable Tray and 5-Module
Chassis to the 23” mounting bracket as illustrated in Figure 6. Provide proper support while
mounting the Cable Tray and 5-Module Chassis to the 23” mounting bracket. Secure the
Cable Tray and 5-Module Chassis to the equipment rack using the rack mount screws included
in the Cable Management Kit.
Figure 6: 23” Cable Tray Installation