Omnitron Systems Technology FlexSwitch 6750 FK - Manual (Page 6)

• Prepare a power cable using a three conductor insulated wire (not supplied)
with a 14 AWG gauge minimum. Cut the power cable to the length required.
• Strip approximately 3/8 of an inch of insulation from the power cable
wires.
• Connect the power cables to the iConverter Chassis by fastening the
stripped ends to the DC power connector.
WARNING: Note the wire colors used in making the positive, negative
and ground connections. Use the same color assignment for the connection
at the circuit breaker.
• Connect the power wires to the circuit breaker and switch the circuit breaker
ON. If any modules are installed, their Power LED should indicate the
presence of power.
Rear of 2-Module Chassis with DC Power Connector
NEVER ATTEMPT TO OPEN THE CHASSIS OR SERVICE THE
POWER SUPPLY OR FAN MODULE. OPENING THE CHASSIS
MAY CAUSE SERIOUS INJURY OR DEATH.
THERE ARE NO USER REPLACEABLE OR SERVICEABLE
PARTS IN THIS UNIT.
WARNING!!!
Page 6