MacDon R85 Rotary Disc 13 Foot Self-Propelled Windrower Header - Manual (Page 100)

MAINTENANCE AND SERVICING
7.2 Torque Specifications
The following tables give correct torque values for various bolts, cap screws, and hydraulic fittings.
• Tighten all bolts to the torques specified in chart (unless otherwise noted throughout this manual).
• Replace hardware with the same strength and grade bolt.
• Check tightness of bolts periodically, using the tables below as a guide.
• Torque categories for bolts and cap screws are identified by their head markings.
7.2.1 SAE Bolt Torque Specifications
Torque values shown in this table are valid for non-greased,
or non-oiled threads and heads. Therefore, do NOT grease
or oil bolts or cap screws unless otherwise specified in
this manual.
Table 7.1 SAE Grade 5 Bolt and Grade 5 Free Spinning
Torque (ft·lbf)
(*in·lbf)
Torque (N·m) Nominal
Size (A)
Min. Max. Min. Max.
1/4-20 *106 *117 11.9 13.2
5/16-18 *218 *241 24.6 27.1
3/8-16 32 36 44 48
7/16-14 52 57 70 77
1/2-13 79 87 106 118
9/16-12 114 126 153 170
5/8-11 157 173 212 234
3/4-10 281 311 380 420
7/8-9 449 496 606 669
1-8 611 676 825 912
Figure 7.1
A - Nominal Size B - SAE-8
C - SAE-5 D - SAE-2
169455
92
Rev. E