MacDon R85 Rotary Disc 13 Foot Self-Propelled Windrower Header - Manual (Page 122)

MAINTENANCE AND SERVICING
Figure 7.16: Cutterbar Filler Plug Locations
9. Locate one of the two filler plugs along the top of the
cutterbar. Refer to Figure 7.16: Cutterbar Filler Plug
Locations, page 114
10. Clean around either filler plug (A) and remove one plug
with an 8 mm hex Allen L-key.
NOTE: Rotate disc to expose filler plug if
necessary.
11. Place a suitably sized container under the cutterbar
drain hole (A).
12. Remove plug (A) with an 8 mm hex Allen L-key and
allow sufficient time for lubricant to drain.
IMPORTANT
Do NOT flush the cutterbar.
13. Replace drain plug (A) and tighten.
14. Safely dispose of lubricant.
15. Add lubricant. See Filling the Cutterbar Lubricant,
page 115 .
Figure 7.17
169455
114
Rev. E