Retsch Cryomill - Manual (Page 14)

Transport, scope of delivery, installation
14
NOTICE
Atmospheric humidity
– Electronic and mechanical components may be damaged and the
performance data alter to an unknown extent.
• Do not exceed the admissible range for atmospheric humidity.
Pos : 5. 15 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Aufs tell en des Ger ät es @ 0\ mod_1226498849756_9.doc @ 3464 @ 2 @ 1
4.5 Installation of the machine
Pos : 5. 16 /00003 St andard Kapit el/ General M odul Aufst ellungshöhe @ 0\ mod_1228918538349_9.doc @ 4724 @ @ 1
Installation height: maximum 2000 m above sea level
Pos : 5. 17 /00004 Warnhinweis e/H 0055 HIN WEIS Cr yoMill D ampf-Fahne @ 4\ mod_1314082098654_9.doc @ 25428 @ @ 1
NOTICE
Property damage
A very cold vapour plume escapes from the nitrogen gas outlet.
–
The vapour plume can greatly cool objects. This is why the humidity in the
air condenses.
• The area above the nitrogen gas outlet (B) up to the ceiling must be
kept free.
Pos : 5. 18 /00004 Warnhinweis e/H 0004 HIN WEIS Boden Aufst ellen Vibr ationen Boden @ 0 \ mod_1228918882236_9. doc @ 4774 @ @ 1
NOTE
Installation
–
Depending on the operating status of the mill, there may be slight
vibrations.
• Place the mill on an even, flat and balanced supporting surface only.
The supporting surface must be stable and must not vibrate.
Pos : 5. 19 /00004 Warnhinweis e/H 0002 HIN WEIS Aufs tell ung Z ugang G erätestec kdos e @ 0\ mod_1233836960983_9.doc @ 5820 @ @ 1
NOTICE
Installation of the machine
–
It must be possible to disconnet the machine from the mains at any time.
• Install the machine such that the connection for the mains cable is
easily accessible.
Pos : 5. 20 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Trans port sicherung ent fer nen @ 0\ mod_1227530921618_9.doc @ 3980 @ 2 @ 1
4.6 Removing the transport safeguard
Pos : 5. 21 /00004 Warnhinweis e/H 0018 HIN WEIS Trans port sicherung @ 2 \ mod_1278053972635_9. doc @ 20540 @ @ 1
NOTICE
Transport safeguard
–
Components may be damaged.
• Operate the machine only without the transport safeguard or
transport the machine only with transport safeguard.
Pos : 5. 22 /00010 Bedi enungsanleit ung en Kapitels ammlungen/Cr yoM ill II /0006 Tr ansport, Li ef erumf ang und Aufs tell en /Cr yoMill II M odul Auspac ken und Tr ans portsic her ung entf ernen @ 5\ mod_1343829053087_9. doc @ 33048 @ @ 1
• Place the device on a stable table.
• Pull the device carefully beyond the edge of the table in order to be able to
reach the screw (TA).