Retsch Cryomill - Manual (Page 39)

Operating the machine
39
The display advances one program each time the button is pressed
- - > P1 > P2 > P3 > P4 > P5 > P6 > P7 > P8 > P9
– The SET button (B15) is blocked in the “- -” mode
Pos : 6. 33 /00005 Ü berschrif ten/ 1. 1. 1 Ü bersc hrift en/ 111 Ver mahl ung mit Pr ogramm @ 5 \ mod_1344590647615_9. doc @ 34050 @ 3 @ 1
5.7.2 Grinding with program
Pos : 6. 34 /00010 Bedi enungsanleit ung en Kapitels ammlungen/Cr yoMill II /0007 Bedi enung/0025 Cr yoMill II Modul Ver mahlung mit Programm @ 5\ mod_1344512746227_9. doc @ 34005 @ 4444 @ 1
Fig. 33: Grinding with program
5.7.2.1 Selection of a program
• Press the PROG button (B15) until the required program is shown in the
memory display.
– The display advances one program each time the button is pressed .
- - > P1 > P2 > P3 > P4 > P5 > P6 > P7 > P8 > P9
– The buttons B8, B7, B9 are blocked due to the selection of a program.
5.7.2.2 Display of the program grinding parameters
Precooling
• Press the precooling button (B10).
– The set time for precooling appears in the time min (B9) display.
Grinding time
• Press the grinding time button (B11).
– The set time for the grinding time appears in the time min (B9) display.
Intermediate cooling
• Press the intermediate cooling button (B12).
– The set time for the intermediate cooling appears in the time min (B9)
display.
5.7.2.3 Create/change a program
• Press the PROG button (B15) until the required program (memory space) is
displayed in the memory display.
• Press the SET button (B15).
– All displays and the corresponding LEDs for which settings are possible light
up or flash.
B15 B7 B8 B9 B10 B11 B12