RKI Instruments SM-2009U - Manual (Page 16)

12 • Overview
Chapter 3: Preparing to Use the SM-2009U
Overview
There are four tasks that must be completed before you can begin to use
the SM-2009U: hardware assembly, setting the bump test and calibration
parameters, connecting calibration gas, and installing the Single Module
Data View Software on your computer. This chapter describes how to
assemble the parts that are shipped with the SM-2009U and set the
bump test and calibration parameters. It also describes how to install the
Single Module Data Viewer Software on a Windows based personal
computer.
Hardware Assembly
The hardware assembly consists of connecting the AC adapter, installing
the air filter, connecting the sample tubing, and setting the SM-20090U’s
bump test and calibration parameters. Perform the following to complete
the hardware assembly
1. Place the SM-2009U on a convenient table top near an AC wall
socket in a well ventilated area. A location near a window that can
be opened is best so that the exhaust can be routed to the window.
2. Insert the round plug on the end of the AC adapter’s cable into the
power jack on the back of the SM-2009U.
3. Connect the AC adapter’s wall plug into a wall AC socket.
4. Install the air filter so that the arrow on the filter that indicates
direction of flow is pointing towards the AIR fitting. Push the open
end of the flexible tube that is on one end the filter onto the AIR
fitting on the back of the SM-2009U.
5. Install the 10 foot long 5/16” ID flexible tube that is included with
the SM-2009U on the exhaust fitting. Route the tube to an area
where the exhaust can be safely dispersed, such as an open
window.