RKI Instruments SM-2009U - Manual (Page 42)

38 • Calibration and Bump Test Records
NOTE: The USB port on the front of the calibration station cannot be
used to connect the SM-2009U to a computer, only to save
calibration and bump test records to a USB flash drive.
1. Confirm that the AC Adapter is connected to the SM-2009U and to
an AC wall socket.
2. Press and hold the SM-2009U’s POWER button. The LEDs will turn
amber and the internal pump will turn on momentarily.
3. When the pump stops and the BUMP and CAL. LEDs turn off,
release the POWER button.
4. The COPY LED will be off or on steadily and the CHARGE LED will
be blinking green.The amount of free memory in the SM-2009U will
dictate the condition of the COPY LED (see “Available Memory in
the SM-2009U” on page 37).
5. Install a USB flash drive into the USB port on the front of the SM-
2009U. The SM-2009U will take a few seconds to determine how
much memory is available in the flash drive.
• If the flash drive’s available memory it is not enough for the
contents of the SM-2009U’s memory, the COPY LED will
alternate between green and red. Enough memory will have to
be cleared in the flash drive to make room for the records in the
SM-2009U’s memory.
• If there is enough available memory in the flash drive for the
contents of the SM-2009U’s memory, the COPY LED will begin
flashing in the same color that it was before installing the flash
drive.
6. Press and release the COPY button. The COPY LED will become
solid red while the records in the calibration station’s memory are
copied to the flash drive. In addition, the flash drive’s LED will begin
to blink.
7. When the COPY LED returns to its original color and begins
blinking again and the flash drive’s LED stops blinking, the copy
operation is complete. Remove the flash drive from the USB port.