RKI Instruments M2A - Manual (Page 60)

55 M2A Transmitter Operator’s Manual
for 5 seconds to enter Modbus Mode. Release the buttons when the following screen appears.
2. To exit Modbus Mode, press and release the DOWN/NO button. The M2A will return to
normal operation.
To continue in Modbus Mode, press and release the UP/YES button. The current ENABLED/
DISABLED setting will appear.
3. If you want to change the currently displayed parameter, use the UP/YES and DOWN/NO
buttons to adjust it to the desired setting, then press ENTER to continue to the next parameter.
If the currently displayed parameter setting is OK, press the ENTER button to proceed to the
next parameter.
Table 11 lists the M2A Modbus Mode parameters you can set. Table 11 also lists the factory set
value for each parameter.
Set Up
Modbus?