RKI Instruments GX-2009 - Manual (Page 4)

4 • Introduction
Introduction
NOTE: The bump test function in Calibration Mode is included
in instruments with firmware version 03955 or later
installed. See page 48 for a description of the bump test
function. GX-2009 instruments shipped after May 2011
include the bump test function. Instruments that have a
serial number starting with 04516 or later shipped from
the factory with the bump test function available.
Instruments that have a serial number starting with
04515 did not include the bump test function when
shipped from the factory. The factory setting for the
bump test function is off.
CAUTION: Read and understand this manual before using the
GX-2009 User Setup Program. Also read and
understand the GX-2009 Operator’s Manual
included with the GX-2009 portable gas monitor.
Using an advanced detection system consisting of up to four gas
sensors, the GX-2009 Personal Gas Monitor detects the
presence of combustible gases, oxygen (O
2
), carbon monoxide
(CO), and hydrogen sulfide (H
2
S) simultaneously. The
GX-2009’s compact size and easy-to-use design make it ideally
suited for a wide range of applications as described in the GX-
2009 Operator’s Manual. Please read the GX-2009 Operator’s
Manual first before using the GX-2009 User Setup Program.
The GX-2009 User Setup Program allows you to change various
instrument parameters not accessible in the GX-2009’s
Calibration Mode or User Setup Mode. It also allows you to save
parameter configuration files based on instruments’ parameter
settings that can be viewed or used to update another
instrument’s parameter settings
The purpose of this manual is to explain how to use the GX-
2009 User Setup Program. You will learn how to:
• install and launch the program