Ethernet connection, Dial-up connection, Digital input connection – SATEC ETC2002 User Manual
Page 11
Chapter 2 Installation
Electrical Installation
ETC2002 Network Communicator
11
Ethernet Connection
Plug the end of the Ethernet cable that came with your device into the wall
Ethernet jack or into the Ethernet hub jack, and the other end into the RJ45
jack at the front of the ETC2002 marked COM1/ETHERNET.
Figure 2-12 Network Connections
See
Internet Connections
in Chapter 3 and
Configuring the Network
in
Chapter 5 for instructions on how to program your device for networking via
Ethernet.
Dial-Up Connection
If you ordered your ETC2002 with the modem option, plug the end of the
standard phone cord into the wall jack, and the other end into the RJ11 jack
at the front of the ETC2002 marked COM2/TEL.LINE.
The device modem provides two modes of operation:
• Regular dial-in connection to the ETC2002 server from
a remote computer through Dial-Up networking.
• Dial-out connection to a remote server via your Internet
service provider – used for eXpertPower
™ services.
See
in Chapter 5 for instructions on how
to program your device for Dial-Up networking.
Digital Input Connection
The ETC2002 has four optically isolated dry-contact digital inputs for
monitoring external digital signals.
Figure
2-13 Digital Input Connections